Flashpro Overrun Fuel Cut Delay, You can find this under the Fuel settings.

Flashpro Overrun Fuel Cut Delay, A short delay makes the vehicle jerky There are several things to check in order to reduce rev hang. I'd look over that page first and make sure your settings are good to go. Go to calibrations tab in flashpro manager with a tune selected and select fuel, there will be overrun fuel cut delay. As for why it isn't working, it's hard to say without seeing what you've tried. I'm sure setting it as low as 10 would basically eliminate the rev hang, if that's what If you end up using this option, make sure you adjust the "Overrun fuel cut delay" to about 40-50 (or lower)for a smoother throttle closing. F. スロットルレスポンスの調整 1<Calibration> ボタンをクリックし、<Fuel>ボタンを選択します。 2Overrun fuel cut delayの数値を下記推奨値に変更します。 Fuel cutoff delay - the delay before the fuel is cut on overrun, by gear and rpm. My dyno . Note that not all vehicles may have these options - if the options are missing, then it could be that those vehicles do not have the ECU We have our FlashPro fuel cut delays set around 30 for all gears, and the rev hang is greatly reduced. Modify the Overrun fuel cut delay settings for each gear. fgm, o2w, tj, h5pnfp, hr, cdxo, fl0hr, nmptl, fox, 4u,